EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE Starting the Engine [b] Check the oil feed and return lines at the turbocharger for tightness. Shut down the engine and tighten them if necessary. Before operating the engine, do the work described under "Before Starting the Engine." Start the engine as follows: NOTICE: 4. Shut down the engine. Never attempt to start any Mercedes-Benz electronic engine using ether or any other starting fluid. Serious engine damage could result. 5. Approximately five minutes after shutdown, check the engine oil level. If necessary, add oil up to the maximum fill level on the oil dipstick. 6. Check all the mounting fasteners on the engine for tightness.
Checking the Coolant Level (Hot Check) Check the coolant levels as follows: To avoid injury when working near or on an operating engine, remove loose items of clothing and jewelry. Tie back or contain long hair that could be caught in any moving part causing injury. PERSONAL INJURY 1. Allow the engine to run for approximately five minutes at a moderate speed. 1. Turn on the ignition switch. 2. With the accelerator pedal in the idle position, start the engine. 3. Check the engine for leaks. [a] Check all hoses, hose clamps, and pipe unions on the engine for tightness. Shut down the engine and tighten them if necessary. All information subject to change without notice. (Rev.
04/08) 25 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION