MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE CLEANING AND STORAGE Cleaning the Cooling System Special precautions should be taken for a stored engine to protect the its interior and exterior. Important: Collect the used coolant, cleaning solutions, and washing liquids and dispose of them in an environmentally responsible manner. Cleaning the Engine Important: Observe all environmental protection regulations. Clean as follows: High-Pressure Cleaning Equipment NOTICE: Information on suitable cleaning and protective products is available from any authorized dealer. Note the equipment manufacturer's operating instructions.

Clean at moderate pressures only; otherwise the fins of the radiator grille could be damaged. 1. First remove debris (dust, insects, etc.) from the fins of the radiator grille. NOTICE: To prevent damage to engine components, keep the water moving at all times while cleaning. Never direct water onto electrical components, plug connectors, seals or flexible hoses. To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. EYE INJURY Comply with the minimum working distance between the high-pressure nozzle and the surface being cleaned:

Approximately 28 inches (700 mm) for circular pattern jets 2. Remove the debris by blowing them through with compressed air or spraying them out with water. Work from the rear of the radiator (in the opposite direction of the normal cooling air flow). Approximately 12 inches (300 mm) for 25-degree flat jets and dirt cutters All information subject to change without notice. (Rev. 04/08) 31 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION