CLEANING AND STORAGE 3. Drain the coolant when the engine is cold. For detailed procedures, see the vehicle/chassis maintenance manual. For types of coolant, refer to the “Service Products” section. HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 4. If the HVAC unit is connected to the cooling system, open the regulating valves all the way. Degreasing Degrease as follows: 1.
Fill the cooling system with a 5% solution (1.6 ounces per quart of water—50 grams per liter) of a mildly alkaline cleaning agent, such as sodium carbonate. 3. Drain all the cleaning solution. 4. Flush the cleaning solution from the cooling system. [a] Immediately after draining the cleaning solution, flush the system with clean water. 2. Run the engine at moderate speed until the thermostat starts to open, at an operating temperature of approximately 80°C (176°F). Then run it for about five minutes longer. Shut down the engine and allow it to cool to approximately 50°C (112°F). [b] Once the clean water has drained, fill the system again with clean water. [c] Run the engine.
Allow the engine to warm up to approximately 80°C (176°F), and then run it about five minutes longer. [d] Drain the hot water. 5. Fill the cooling system with new coolant. For detailed procedures, see the vehicle/chassis maintenance manual. For types of coolant, refer to the “Service Products” section. 32 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION