MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE Rear Engine Power Take-Off (REPTO) replace the damper. Regardless of the condition, the torsional coupling must be replaced at normal engine overhaul. The REPTO accessory drive is an option on the MBE 4000 engine. The drive provides continuous live power anytime the engine is operating. The REPTO is driven by the camshaft gear and is an integral part of a unique SAE#1 flywheel housing. All REPTO installations require a torsional coupling installed at the flange of the drive unit (i.e. hydraulic pump). The torsional coupling incorporates a rubber element designed to reduce the unwanted stresses from reaching the engine. See Figure 34. 2.

Inspect the torsional damper rubber element as follows: [a] Check the rubber element for bulges or cracks. If damage is found replace the damper. [b] Inspect the rubber element teeth for wear. If the teeth are worn to less than one-half of the new part length (11.0 mm [0.433 in.]), replace the torsional damper. See Figure 35. Figure 34 MBE 4000 REPTO Connection Illustration Figure 35 REPTO Torsional Damper REPTO Torsional Damper Inspection Inspect the REPTO torsional damper as follows: REPTO Torsional Damper Cleaning Clean the REPTO torsional damper as follows: 1. Inspect the outer casing of the torsional damper for dents or bulges.

If damage is found All information subject to change without notice. (Rev. 04/08) 87 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION