MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

MAINTENANCE Cooling System Inspecting EYE INJURY NOTE: Before doing this inspection, do either "Coolant Concentration Checking," or "Coolant Flushing and Changing." To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. Inspect the cooling system as follows: 5. Apply no more than 140 kPa (20 psi) air pressure intermittently to help dislodge sediment buildup in the core. HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature.

Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 6. Drain the radiator, and flush the radiator until clean water flows from the radiator. Remove the flushing gun. 7. When the coolant has drained, install the coolant drain plug on the radiator. 8. Add coolant in the specified concentration until the maximum mark on the surge tank is reached. 1. Inspect the radiator, condenser, coolant pump, engine oil cooler, freeze plugs, and heat exchanger for damage and leaks. 9. Start the engine and run it for about one minute at varying speeds to release air pockets in the cooling system. Ensure the heater valve is still open.

Check the coolant level and add more coolant if necessary. 2. Check all cooling system pipes and hoses for damage and leaks; ensure they are positioned to avoid chafing, and are securely fastened. 3. Check the outside of the radiator and condenser for blockage. Check fins for damage; straighten them if necessary. 10. Shut down the engine, close and tighten the cap on the surge tank. 86 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION