Komatsu — BEFORE STARTING ENGINE

OPERATION MACHINE OPERATIONS AND CONTROLS 9. Seat belt and mounting clamps Check that there is no abnormality in the seat belt or mounting clamps. If there is any damage, replace with new parts. 10. Check bucket with hook (if equipped) for damage. Check the hook, catcher and hook foot for damage. If damage is found, contact your Komatsu distributor for repair. CHECKS BEFORE STARTING Always check the items in this section before starting the engine. CHECK COOLANT LEVEL, ADD WATER Do not open the radiator cap unless necessary. When checking the coolant, wait for the engine to cool down and check the sub tank.

Immediately after the engine is stopped, the coolant is at a high temperature and the radiator is under high internal pressure. If the cap is removed to drain the coolant in this condition, there is a danger of burns. Wait for the temperature to go down, then turn the cap slowly to release the pressure before removing it. 1. Open the door at the rear left of the machine, and check if the cooling water in sub-tank (1) (shown in the diagram on the right) is between the FULL and LOW marks. If the water level is low, add water to the FULL level through the filler port of sub-tank (1). 2. After adding water, tighten the caps securely. 3.

If the sub tank is empty, there is probably leakage of water. After inspecting, repair any abnormality immediately. If there is no abnormality, check the water level in the radia- tor. If the water level is low, add water to the radiator, then fill the reserve tank (1). 127 WARNING AM096120A