Komatsu — UNLOADING

OPERATION TRANSPORTATION UNLOADING 1. Perform loading and unloading on firm, level ground only. Maintain a safe distance from the edge of a road. 2. Properly apply the brakes on the trailer and put blocks under the tires to ensure that the trailer does not move. Then fix the ramps in line with the centers of the trailer and the machine. Be sure that both ramps are at the same level. Make the slope of the ramps a maximum of 15є. Set the distance between the ramps to match the center of the tracks. Ramps Blocks 3. Remove the chains or wire rope holding the machine. Distance between ramps Block 4. Start the engine. Carry out the warming-up operation thoroughly in cold weather. 5.

Set the safety lock lever (1) to the FREE position. Free Lock 6. Set the travel speed selector switch to the LOW position. To switch the travel speed, press travel speed selec- tor switch (1).The travel speed is displayed as Lo, Mi, or Hi on the monitor display. Display portion 7. Turn auto-deceleration switch (1) OFF and operate the fuel control dial to set the engine speed to low idling. Each time auto-deceleration switch (1) is pressed, it switches OFF ON OFF in turn. When auto-deceleration switch (1) is turned OFF, display monitor (2) goes out. Monitor display portion 181