Komatsu — DISCHARGED BATTERY

TROUBLESHOOTING OPERATION DISCHARGED BATTERY mounted on the machine. Always remove the battery before charging it. When removing, disconnect the cable from the ground terminal first. When checking or handling the battery, stop the engine and turn the starting switch key to the OFF position. The battery generates hydrogen gas, so there is dan- ger of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause sparks. When installing, connect the cable to the positive + terminal first. Battery electrolyte is diluted sulfuric acid, and it will attack your clothes and skin.

If it gets on your clothes or on your skin, wash it off immediately with large amounts of water. If it gets into your eyes, wash it out with fresh water, and consult a doctor. When handling batteries, always wear protective gog- gles and rubber gloves. When removing the battery, first disconnect the cable from the ground (normally the negative (-) terminal). When installing, install the positive (+) terminal first. If a tool touches the positive terminal and the chassis, there is danger that it will cause a spark, be extremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause an explosion.

When installing the terminals, install them tightly. When removing or installing the terminals, check which is the positive (+) terminal and which is the neg- ative (-) terminal. Green rust around the terminals is a cause of self-dis- charge of the battery. Clean the terminals with sandpa- per. After removing the rust, coat the terminals thinly with grease before installing. 194 WARNING