MAINTENANCE LUBRICANTS, COOLANT AND FILTERS Minimum service relating to the electric system is a check of fan belt tension, check of damage or wear in the fan belt and check of battery fluid level. Never install any electric components other than those specified by Komatsu. External electrical interference may cause malfunction of the control system controller. Before installing a radio receiver or other wireless equipment, please contact your Komatsu distributor. When working at the seashore, carefully clean the electric system to prevent corrosion. When installing an operator's cab cooler or any other elec- trical equipment, connect it to an independent power source connector.
The optional power source must never be connected to the fuse, starting switch, or battery relay. HANDLING HYDRAULIC SYSTEM During and after operations, the hydraulic system is at high temperature. During operations, it is also under high pres- sure, so pay careful attention to the following when carry- ing out inspection and maintenance of the hydraulic system. Stop the machine on level ground, lower the bucket to the ground, and set it so that there is no pressure on the cylin- der circuit. Stop the engine. Immediately after operations, the hydraulic oil and lubricat- ing oil are under pressure and at high temperature, so wait for the temperature to go down before starting mainte- nance.
Even when the temperature goes down, there may still be internal pressure. When loosening plugs, screws, or hose connections, do not stand directly in front. Loosen them gradually to release any internal pressure before removing. When carrying out inspection or maintenance of the hydraulic circuits, bleed the air to release the internal pres- sure. Minimal inspection or maintenance consists of checking the hydraulic oil level, replacing the filters, and changing the hydraulic oil. When removing high-pressure hoses, check that the O-ring is not damaged. If it is damaged, replace it. 215