Komatsu — TIGHTENING TORQUE LIST

TIGHTENING TORQUE SPECIFICATIONS MAINTENANCE TIGHTENING TORQUE SPECIFICATIONS TIGHTENING TORQUE LIST If nuts, bolts, or other parts are not tightened to the specified torque, it will cause looseness or damage to the tightened parts, and this will cause failure of the machine or problems with operation. Pay careful attention when tightening parts. CAUTION Unless otherwise specified, tighten the metric nuts and bolts to the torque shown in the table below. The tightening torque is determined by the width across the flats of the nut and bolt.

If it is necessary to replace any nut or bolt, use a Komatsu genuine part of the same size as the part that was replaced Apply the following table for Hydraulic Hose .

220 Thread diam- eter a(mm) Width across flat b(mm) Tightening torque Target value Service limit N•m kgf•m N•m kgf•m 6 10 13.2 1.35 11.8 - 14.7 1.2 - 1.5 8 13 31 3.2 27 - 34 2.8 - 3.5 10 17 66 6.7 59 - 74 6.0 - 7.5 12 19 11 11.5 98 - 123 10.0 - 12.5 14 22 177 18 157 - 196 16.0 - 20.0 16 24 279 28.5 245 - 309 25.0 - 31.5 18 27 382 39 343 - 425 35.0 - 43.5 20 30 549 56 490 - 608 50.0 - 62.0 22 32 745 76 662 - 829 67.5 - 84.5 24 36 927 94.5 824 - 1030 84.0 - 105.0 27 41 1320 135.0 1180 - 1470 120.0 - 150.0 30 46 1720 175.0 1520 - 1910 155.0 - 195.0 33 50 2210 225.0 1960 - 2450 200.0 - 250.0 36 55 2750 280.0 2450 - 3040 250.0 - 310.0 39 60 3280 335.0 2890 - 3630 295.0 - 370.0 Thread diameter a(mm) Width across flat b(mm) Tightening torque Target value Service limit N•m kgf•m N•m kgf•m 14 19 29.4 3.0 27.5 - 39.2 2.8 - 4.0 18 24 78.5 8.0 58.8 - 98.1 6.0 - 10.0 22 27 117.7 12.0 88.3 - 137.3 9.0 - 14.0 24 32 147.1 15.0 117.7 - 176.5 12.0 - 18.0 30 36 215.7 22.0 176.5 - 245.2 18.0 - 25.0 33 41 255.0 26.0 215.7 - 284.4 22.0 - 29.0