Komatsu — INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250 HOURS)

MAINTENANCE PROCEDURE MAINTENANCE BLEEDING AIR FROM HYDRAULIC SYSTEM For details, see "STARTING ENGINE (PAGE 139)". If it is necessary to refer to the items for starting the engine, moving the machine off, steering, or stopping, see the OPERATION section. 1. Bleeding air from pump 1) Loosen air bleed plug (1) and check if oil oozes out. 2) If the oil does not ooze out, remove the drain hose from the hydraulic pump case and fill the pump case completely with hydraulic oil through drain port (2). Hold the removed hose firmly, keeping the mouth- piece higher than the oil level in the hydraulic tank so that oil will not spill out of the hose.

3) After air bleeding is completed, first tighten air bleed plug (1) and then install the drain hose. 9JH03653A NOTICE If the drain hose is installed first, oil will spurt out of air bleed plug (1). If the pump is run when the pump case is not full of oil, there will be abnormal generation of heat, and this will lead to premature failure of the pump. 2. Starting engine Start the engine. For details, see "STARTING ENGINE (PAGE 139)". Run the engine at low idle for 10 minutes after starting, then start operations. 3. Bleeding air from cylinders 1) Run the engine at a low idle and extend and retract the cylinders 4 to 5 times to a point 100 mm from the end of the stroke.

(Be careful not to operate to the end of the stroke.) 2) Next, operate each cylinder 3 to 4 times to the end of its stroke. 3) Finally, operate each cylinder 4 to 5 times to the end of its stroke to completely remove the air. NOTICE If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing. 4. Bleeding air from swing motor (bleed the air only when the oil inside the swing motor case has been drained and refilled) When oil has been drained from inside swing motor case and refilled. 1) Run the engine at low idle, loosen drain hose (1), and check that oil oozes out from drain hose (1).

NOTICE When doing this, do not operate the swing. 9JM0444A 2) If the oil does not ooze out, stop the engine, remove drain hose (1), then fill the motor case with hydraulic oil. 3) After completion of bleeding air, install drain hose (1). 246