MAINTENANCE PROCEDURE MAINTENANCE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CAR- TRIDGE The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. Prepare the following: Refill capacity of oil pan: 35 liters Filter wrench 1. Remove undercover (1) at the bottom of the machine, then set a container under drain valve (P) to catch the drained oil. 2. To prevent getting oil on yourself, lower the lever of drain valve (P) slowly, drain the oil, then raise the lever to close the valve. 9JH02630A Lever 3.
Open the cover at the rear right, then use a filter wrench to turn filter cartridge (1) to the left to remove it. 4. Clean the filter holder, fill the new filter cartridge with clean engine oil, coat the packing surface and thread of the filter cartridge with engine oil (or coat it thinly with grease), then install the filter cartridge to the filter holder. REMARK Check that there is no old packing stuck to the filter holder. If there is any old packing remaining, it will cause oil leakage. 9JM04448A 5. When installing, bring the packing surface into contact with the seal surface of the filter holder, then tighten it fur- ther 3/4 - 1 turn. 260 WARNING