MAINTENANCE MAINTENANCE PROCEDURE CLEAN HYDRAULIC TANK STRAINER The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the hydraulic tank strainer. When the oil filler cap is removed, oil may spurt out, turn the cap slowly to release the internal pres- sure, then remove it carefully. 1. Loosen 6 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring (2), so push the cover down when removing the bolts. 2. Pull up the top of rod (3), and remove spring (2) and strainer (4). 3.
Remove the dirt stuck to strainer (4), then wash it in clean diesel oil or flushing oil. 9JH02677A If strainer (4) is damaged, replace it with a new one. 4. Refit strainer (4) by inserting it into the tank projecting part (5). 5. Assemble it so that the protruding part at the bottom of cover (1) holds spring (2), then tighten the cover with the bolts. CLEAN ENGINE BREATHER The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. If compressed air, high-pressure water, or steam hit your body directly, or they cause dirt or dust to be blown up, there is a danger of serious injury.
Always use safety glasses, dust mask, or other protec- tive equipment. 1. Wipe away dust around the breather. 2. Loosen the clamp and remove the hose. Remove breather (1). 3. Clean the breather body with light oil or cleaning oil. 4. Replace O-ring with new one. Coat a new O-ring with engine oil, set it, then install breather (1). 5. Check the breather hose. If caked oil (sludge) adheres to the inside, replace the hose with a new one. 9JH02678A 271 WARNING WARNING