Komatsu — CHANGE OIL IN HYDRAULIC TANK

MAINTENANCE PROCEDURE MAINTENANCE EVERY 5000 HOURS MAINTENANCE Maintenance for every 250, 500 and 1000 hours service should be carried out at the same time. CHANGE OIL IN HYDRAULIC TANK The parts and oil are still at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before servicing the hydraulic tank. When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the internal pressure, then remove it carefully. NOTICE If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than dur- ing normal bucket operations.

For details, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 225)" when carrying out maintenance. Prepare the following. Refill, capacity: 188 liters Prepare a handle for the socket wrench set. 1. Swing the upper structure so that the drain plug at the lower part of the suction tube comes to the middle of the left or right track. 2. Retract the arm and bucket cylinders to the stroke end, then lower the boom and put the bucket teeth in contact with the ground. 3. Lock the safety lock lever and stop the engine. 4. After the tank has cooled, remove the cap from oil filler (F) on the hydraulic tank. 5. Set an empty oil container under the drain plug under the machine.

Remove drain plug (P) and drain the oil. Check the O-ring installed on plug (P). If it is damaged, replace the O-ring. After draining the oil, tighten drain plug (P). Tightening torque: 69 ± 10 N•m. When removing drain plug (P), be careful not to get oil on your- self. 9JH02679A 6. Add the specified amount of engine oil through oil filler port (F). Check that the oil level is between H and L on the sight gauge. For details of the method of bleeding the air, see "CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL (PAGE 131)". 274 WARNING