Komatsu — TRAVELLING ON SLOPES

SAFETY MACHINE OPERATION SAFETY TRAVELLING ON SLOPES To prevent the machine from tipping over or slipping to the side, do as follows. When travelling on slopes, keep the work equipment approximately 20 to 30 cm above the ground. In case of emergency, quickly lower the work equipment to the ground to immediately help stop the machine. When travelling up slopes, set the operator's cab facing uphill, when travel down slopes, set the operator's cab fac- ing downhill. Always check the firmness of the ground under the front of the machine when travelling. When travelling up a steep slope, extend the work equip- ment to the front to improve balance.

Keep the work equip- ment approximately 20 to 30 cm above the ground, and travel at low speed. When travelling downhill, lower the engine speed, keep the travel lever close to the neutral position, and travel at low speed. Always travel straight up or down a slope. Travelling at an angle or across the slope is extremely dangerous. Do not turn on slopes or travel across slopes. Always go down to a flat place to change the position of the machine, then travel up the slope again. Travel on grass, fallen leaves, or wet steel plates with low speed. Even with slight slopes there is a danger that the machine may slip.

If the engine stops when the machine is travelling on a slope, move the control levers immediately to the neutral position and start the engine again. 40