Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION ADJUSTMENT SEAT ADJUSTMENT WARNING height. Amount of adjustment: 50 mm (2.0 in) (D) Setting seat for weight (G) Adjusting headrest height Move the headrest (6) up or down. Amount of adjustment: 50 mm (2.0 in) 3 - 74 When adjusting the po sition of the operator's seat, always set the work equipment lock l ever to the LOCK positio n to preven t any accidental contact wit Always adjust the operator's seat before s tarting ea ch operation or when th e operato rs change s hift. When adjusting t he seat, put your back ag ainst the backrest and adjust to a position w here the br ake peda l can be fully depresse d.

STANDARD TYPE SEA T ustment (A) Fore-and-aft adj Pull lever (1) up, set the seat to the desired p osition, th en release the lever. ment: 120 mm (4.7 in) Fore-and-aft adjust (B) Adjusting seat a ngle nd push down on the rear of the seat to tilt it Move lever (2) up a backward. Move lever (2) dow n and push down on the f ront of th e seat to tilt it forward. 3 degrees (Tilt forward/tilt back angle) Adjustment range: 1 3 degrees (Tilt forward/ti lt back an (C) Adjusting height Move lever (2) up or is also used to adju of seat down to move the seat up or down. This lever st the seat angle. Adjust the seat angle and Turn grip (3) to adju st the strength of the sus Adjustment range:

( Target) 50 to 120 kg (11 0 to 265 lb (E) Adjusting reclini ng angle Move lever (4) up a nd move the backrest to t he front o r rear. Adjustment range: F ront 24 degrees , Rear 3 degrees \i (F) Lumbar support Turn grip (5) to adju st the tension applied to t he lower