Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION ADJUSTING WORK EQUIPMENT POSTURE WARNING 3 - 105 Stop the machine on flat ground a wheels. nd put blocks in front and behind the Set parking brake lever to the LO Secure the front and rear frames CK position. with the frame lock bar. the work equipment control lever. Always attach the warning tag to Do not go under the work equipme nt when the arm is raised. To support the work equipment securely, use the weight of the work equipmen down.

a strong support that can withstand t and prevent the arm coming from The boom kickout makes it pos sible to set the bucket so that it automatically stops at the desire d lifting height (lift arm higher than horizontal) and the bucket positi oner makes it possible to set the bucket so that it automatically st ops at the desired digging angle. The setting can be adjusted to m atch the working conditions. ADJUSTING BOOM KICKOU T 1. Raise the bucket to the desir control lever at HOLD, then s to the LOCK position and sto 2. Loosen two bolts (1), and a edge is in line with the ce proximity switch (3). Then ti position. 3.

Loosen two nuts (4) to make to 0.197 in) between plate proximity switch (3). Then ti Tightening torque: 14.7 to 19 14.5 lbft) 4. After adjusting, start the engi lever. Check that the lever is when the bucket reaches the 1. Raise the bucket to the desir ed height, set the work equipment et the work equipment lock lever p the engine. djust plate (2) so that the bottom nter of the sensing surface of ghten the bolts to hold the plate in 3. Loosen two nuts (4) to make a clearance of 3 to 5 mm (0.118 (2) and the sensing surface of ghten the nuts to hold in position. .6 N·m (1.5 to 2.0 kgf·m, 10.8 to 4.

After adjusting, start the engi ne and operate the lift arm control automatically returned to HOLD desired height.