. OPERATION OPERATION 3 - 106 ADJUSTING BUCKET PO 1. Lower t he bucket to the angle, r eturn the work eq uipment control lever to H OLD, then set the sto p the 2. Set the attachment selec tor switch to bucket positi 3. Loosen nut (1), then adju st the position of the proxi mity switch so that the rear tip of ba r (2) is in line with the center of the mity switch (3). e clearance between bar (2) and the imity switch (3) is 3 to 5 mm, then position. o 19.6 N·m (1.5 to 2.0 kgf·m, 10.8 to bft) just so that the tip of protector (5) rom the sensing surface of proximity e bolt to hold in position. sensing surface of proxi 4.
Adjust nut (1) so that th sensing surface of prox tighten the nut to hold in Tightening torque: 14.7 t 14.5 l 5. Loosen bolt (4) and ad sensing surface of prox tighten the nut to hold in Tightening torque: 14.7 t 5. Loosen extends 0.5 to 1.0 mm f surface o f proximity switch ( 3), then tighten th e bolt to hold in position. 6. Afte r adjusting, start the engine and raise the lift arm . Operate the to bucket control lever t the TILT BACK po o the DUMP position, the sition and check that th n operate it e lever is automatically returned to reaches the desired digg the HOLD position when the bucket ing angle.