Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION and stop the engine. 3 - 107 ADJUSTING FORK POSITION 1. Lower the forks to the groun return the work equipment co ntrol lever to the HOLD position, then set the work equipment 2. Set the attachment selector s 3. Loosen nut (1), then adjust th e position of the proximity switch so that the rear tip of bar (2) is in line with the center of the switch (3). arance between bar (2) and the switch (3) is 3 to 5 mm, then tion. .6 N·m (1.5 to 2.0 kgf·m, 10.8 to so that the tip of protector (5) the sensing surface of proximity lt to hold in position. he sensing surface of proximity 4.

Adjust nut (1) so that the cle sensing surface of proximity tighten the nut to hold in posi Tightening torque: 14.7 to 19 14.5 lbft) 5. Loosen bolt (4) and adjust extends 0.5 to 1.0 mm from switch (3), then tighten the bo sensing surface of proximity tighten the nut to hold in posi Tightening torque: 14.7 to 19 5. switch (3), then tighten the bo 6. After adjusting, start the engi ne, and raise the lift arm. Dump the fork, then tilt back and automatically to the HOLD po check that the lever returns sition when the fork is horizontal.