. OPERATION TROUBLESHOOTING TROUBLESHOOTING WHEN MACHINE RUNS OUT OF FUEL WARNING METHOD OF TOWING MACHINE WARNING 3 - 124 When starti ng the engine again, check caref ully that the area around the engine is safe before cranking th When star ting the engine after running o ut of fuel, fill with fuel and bleed the air from the fuel sys tem before starting. For details of bleeding the air, see "REP LACE FUEL FILTER CARTRIDG E (PAGE 4-46)". Serious inju ry or death could result if there is of wire rope or method of towing a disabled Always b e sure to check carefully that the for towin g is ample for the weight of the t Never us e a wire rope which has cut stran or kinks (C).
There is danger that the rope operatio n. Always wear leather gloves when handlin Never to w a machine on a slope. During t he towing operation, never stand and the machine being towed. Move the machine slowly and be sure not the wire rope. If there i s a failure in the brake line, the b extremel y careful when towing. NOTICE the machine for a short distances, such as to a place for inspection or maintenance. hine must not be towed for long distances.
Only tow the machine for a short distance s, such as to a place for inspection or The mac hine must not be towed for long For detai ls of the permissible towing load for this machine, see Section "SPECI FICATIONS (PAGE 5-2)" For detai ls of the procedure for towing a machine when it has broken down, ple ase contact your Koma This mach ine must not be towed except in emergencies. When towing the machine, take the fol lowing precautions. Before r eleasing the brakes, put bloc ks under the wheels to prevent the machine from movin g. If the wheels are not bloc ked, the machine may sudde nly move.
When t owing a machine, tow it at a lo w speed of less than 2 km/h (1.2 M PH), and for a dista nce of a few meters to a pla ce where repairs can be carrie d out. The machine should be tow ed only in emergenc ies. If the machine must be moved long distances, use a transporter. If it is im possible to operate the steer ing and brakes of the machine bei ng towed, do not let anyone ride on the machin e. Keep th e angle of the towrope as sma ll as possible. Keep the angle betw een the centerlines of the two machines to withi n 30 degrees. The tow ing machine should normally be of the same class as the mach ine being towed.
Ch eck that the towing machin e and towed machine both ha ve ample braking power and that t he towing machine h as ample rimpu ll to control both machines on the slopes or on the tow road.