Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING 3 - 126 It is dangerous to charge a bat tery when mounted on a machine. Make sure that it is dismounted befo re charging. e battery, stop the engine and turn the position. When checking or handling th starting switch key to the OFF The battery generates hydroge n gas, so there is a hazard of explosion Do not bring lighted cigarettes cause sparks. near the battery, or do anything that wil Battery electrolyte is dilute sul furic acid, and it will attack your clothes and skin. If it gets on your clot off with a large amount of wate fresh water and consult a doct hes or on your skin, immediately wash i r.

If it gets in your eyes, wash it out with or. ys wear protective goggles and rubbe When handling batteries, alwa gloves. When removing the battery, fir st disconnect the cable from the ground (normally the negative (-) termi (+) terminal first. If a tool touches the positive te that it will cause a spark, so be nal). When installing, install the positive rminal and the chassis, there is dange extremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause an explosion. When removing or installing th e terminals, check which is the positive (+) terminal and which is the n egative (-) terminal.

REMOVAL AND INSTALLA TION OF BATTERY 1. Before removing battery, r touches between the posit nuts of the terminal and re 2. After installing the battery, Tightening torque: 5.9 to 9 (0.6 to 3. When installing the batter Insert the hole of the term Tightening torque: 5.9 to 9 (0.6 to 1. Before removing battery, r emove the ground cable (normally connected to the negetive (-) t erminal). If an y tool ive terminal and the chassis, there is danger of sparks being gen erated. Loose n the move the wires from the battery. fix it with the battery hold down. .8 N·m 1.0 kgf·m, 4.3 to 7.2 lbft) y, connect the ground cable last. inal on the battery and tighten the nut.

.8 N·m 1.0 kgf·m, 4.3 to 7.2 lbft) 3. When installing the batter inal on the battery and tighten the n ut REMARK The batteries are on both side s at the rear of the machine. The battery used for the ground is on the right si de of the machine.