Komatsu — GUIDES TO MAINTENANCE

. MAINTENANCE GUIDES TO MAINTENANCE been repaired or replaced and if the have been OIL IN REPLACE the mounting surface, and 4 - 3 DUSTY WORKSITES: as follows: y to see if the air cleaner is dirty or clogged. o avoid clogging. quently. cially the starting motor and alternator, to avoid accumulation of dust. When working at dusty worksites, do Inspect the dust indicator frequentl y to see if the air cleaner is dirty or clogged Clean the radiator core frequently t Clean and replace the fuel filter fre Clean electrical components, espe cially the starting motor and alternator, to a void accumulation o f dust.

When inspecting or changing the o il, move the machine to a place that is free of dus t to prevent dir t from getting into the oil. AVOID MIXING OIL: If a different brand or grade of oil has t o be added, drain the old oil and replace all t he oil with the new b rand or grade of oil. Never mix different brand or gr ade of oil. LOCKING INSPECTION COVERS: Lock inspection cover securely into position with the lock bar. If inspection or maintenance is performed with with inspection cover not locked in positio n, there is a danger that it may be suddenly blow shut by t he wi nd and cause injury to the worker.

BLEEDING AIR FROM HYDRAULIC CIRCU If t he hydraulic oil equipments have disconnected, it is necessary to blee HYDRAULIC FILTER ELEMENT (PA ulic h oses , pipes, et HYDRAULIC TAN PRECAUTIONS WHEN INSTALLING HYDR AULIC HOSES: where there are O-rings or gasket seals, clean orget to assemble the O-rings and gaskets. When removing parts at locations replace with new parts. When doing this, be careful not to f orget to assemble the O-rings and gaskets When installing the hoses, do not t wist or bend them into loops with a small ra dius. This will cause damage to the hos e and drastically reduce its service life. CHECKS AFTER INSPECTION AND MAINT ENANCE:

If y ou forget to perform the checks afte r inspection and maintenance, unexpected problems may occur , and this may lead to serious injury or property dam age. Always do the following: e stopped) nance points been forgotten? ance items been performed correctly? Checks after operation (with engin Have any inspection and mainte Have all inspection and mainten Have any tools or parts been dr inside the machine and get cau Are there any leakage of coolan Have any inspection and mainte Have all inspection and mainten Have any tools or parts been dr opped inside the machine? It is particularl y dangerous i f parts are dropped ght in the lever linkage mechanism. t or oil?

Have all nuts and bolts been tightened? Are there any leakage of coolan t or oil? Have all nuts and bolts been tightened? Check when the engine is running See "TWO WORKERS FOR MA safety for checking when the en Check if the inspected and main Increase the engine speed to ch See "TWO WORKERS FOR MA INTENANCE WHEN ENGINE IS RUNNIN G (PAGE 2-34)" in t he sectio n on gine is running. Pay attention to safety. tenance area is operating normally. eck for fuel and oil leakage. Check if the inspected and main Increase the engine speed to ch