Komatsu — CLEAN INSIDE OF COOLING SYSTEM

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *: Permanent type antifreeze shall meet the requirements of ASTM D3306-03. Stop the machine on level ground when cleaning or changing the coolant. The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. Komatsu Supercoolant (AF-NAC) is strongly recommended wherever available.

To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F). Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F).

Mixing rate of water and antifreeze 4 - 20 Immediate ly after th e engine is s topped, the engine coolant is hot and the pressure inside t he radiato r is high. Removing the cap and d raining the wate r unde r this condit ion could c ause b urns. Allow th e engine to co ol down, then turn the cap slowly to re lease the pressu re. Start the e ngine and flush the sy stem. Befor e standing up or le aving the o perator's seat, se t the work equipment lock lever to the L OCK position.

For detail s of startin g the engine , see "CHE CK BEFORE STARTING ENGINE, ADJUST (PAG E 3-65)" a nd "STARTING ENGINE (PAG E 3-80)" in the OPERATION section of t he Operatio n and Maintenanc e Manual Whe n the undercove r is remove d, there is d anger of touching the fan.

Neve r ent er the rear of the machine when th e engine is runnin Clean the in side of th e cooling system, ch ange the c oolan t accordin g to the table b elow I Antifreeze coolant nterval of cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Permanent type antifreeze (All-season type, *) Every year (autumn) or every 2000 hours whichever comes first Min. atmospheric temperature °C °F Above - 10 -15 -20 -25 -30 Above 14 5 -4 -13 -22 Amount of antifreeze Liters US gal 5.70 6.84 7.79 8.74 9.50 1.51 1.81 2.06 2.31 2.51