. MAINTENANCE SERVICE PROCEDURE Amount of water Liters 9.50 US gal 2.51 Ratio % 50 WARNING stopper, then remove it. the then 4 - 21 13.30 12.16 11.21 10.26 3.51 3.21 2.96 2.71 30 36 41 46 Antifreeze is flammable, so keep it away from flame. Antifreeze is toxic. When removing the drain plug, be careful not to get water containing antifr eeze on you. If it gets in your eyes, lush your eyes with large amount of fresh water and see a doctor a t once.
Use antifreeze and appropriate water for diluting (for details, s ee "COOLANT AND W ATER FOR DILUTION (P AGE 4-5) We recommend use of an antif reeze density gauge to contr ol the mixing proportion Prepare a container whose cap acity is larger than the specif ied coolant volume to c Prepare a hose to supply antifr 1. Stop the engine. 2. Check that the coolant tem perature has gone down enou make it possible to touch the radiator cap surface by then turn radiator cap (1) sl owly until it contacts the stop release the pressure. 3. Following this, push radiato r cap (1), turn it until it contac 4. Set a container in position t o catch drained antifreeze mi 5.
then open valve (2) under t After draining the coolant, c he radiator to drain coolant. lose drain valve (2) and fill wi 6. water. When the radiator is full, sta Keep the engine running a t low idle for 10 minutes un coolant temperature reache s more than 90°C (194°F). 7. Stop the engine, open drai tighten them again. 8. After draining the water, cle an the cooling system with c leaning agent. aning agent. the water filler. For the cleaning method, s ee the instructions for the cle 9. Add coolant mixed with ant ifreeze until it overflows from Decide the proportions of a ntifreeze and water according to the table for the mixi ng rate of water and antifreeze. 10.
To bleed the air from the co oling system, run the engine at low idle for 5 minutes , and for a further 5 minut es at high idle. (When doing this, leave the radiator cap off.)