Komatsu — CHECK OIL LEVEL IN TRANSFER CASE, ADD OIL

. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN TRANSFER CASE, ADD OIL WARNING 6. If the oil level is correct, insert dipstick (G) in the dipstick guide, then tighten the cap. 4 - 23 The parts and oil are at high temperatu re immediat ely after the e ngine is stopped, and may cause burn s. Wait for the temperature to go down before s Carry out this proc edure if there is any sign o f oil on the transfer 1. Start the engi ne and run it at l ow idle for at leas t 5 m 2. Open the cap of oil filler port (F ), remove d ipstick (G), and wipe the oil off with 3. Insert dipstick (G) fully in the oi l filler pipe, t hen take it out again. 4.

The oil level s hould be betwee n the H an d L marks o n dipstick (G). If the oil level i s below the L m ark, add oi l through oi l filler (F). If the oil is abo drain plug (P), ve the H mark, and check the drain the ex oil level ag