. MAINTENANCE SERVICE PROCEDURE TURN, REPLACE BOLT-ON CUTTING EDGE WARNING position. Raise the bucket so that the bottom surface of the bucket is horizontal. right edge to left side). part. If the wear extends to the mounting surface, repair the 4 - 28 It is dangerous if th e work equipment moves by m istake durin g the turning or replaceme nt operation. Set the work equip ment in a stable condition, st work e quipmen lock le ver secure ly to the LOCK Turn or replace th e cutting edge before the wear reache s the edge of the b ucke 1. Raise the buc ket to a suitable height, the n put blocks (A) under prevent the bucket from co ming down 2.
Remove nuts and bolts (1), then remove cutting edg 3. Clean the mo unting surface of cutting ed ge (2). 4. Turn cutting e dge (2) and install i t to the bucket. Wh en turning all it to the opposite side (l eft edge to right side, f the cutting edge are wor n, replace w ace before installin g the cu tting edge. 5. Tighten nuts a nd bolts (1) uniformly so t hat there is no gap between th e bucket and cu tting edge que for mounting bolt: 883 to 1196 N· (90 to 122 kgf· m, 651 to 882 6. Tighten the m ounting bolts again after o perating for several hours