. MAINTENANCE SERVICE PROCEDURE REPLACE BUCKET TEETH (If equipped) BUCKET WITH TIP TOOTH WARNING Raise the bucket so that the bottom surface of the bucket is horizontal. the hatched portion (either left or right) and tap pin (2) out to the opposite side. 4 - 29 If the pin is hit out with stron g force, there is danger that the pin m ay fly out. Chec k that there is no one in t he surrounding area. There is danger of pieces fly ing during the replacement operatio n, so always wea r protective clothing, su ch as safety glasses and gloves. Replace the teeth before th ey wear down as far as t he adap 1.
Raise the bucket to a su itable height, then put blocks (A) the bucket to prevent th e bucket from coming down. 2. Remove pin (2) installe d to the bucket, then remove toot Put a rod (slightly narr ower than the pin) in contact wit 3. Fit new tooth (1) in adap ter (3), push in pin (2) partially by then knock it in with a h ammer. 4. After operating the mac hine for a few hours, check that t does not come out. 5. If mounting bolts (4) or (5) of adapter (3) are loose, tight en them. Tightening torque of m ounting bolt (122 to 136 kgf·m, 882.4 to 983.7 lbft) 3 to 93 kgf·m, 600.3 to 672.7 lbft) (4): 1200 to 1330 N·m (122 to 136 kgf·m, 882.4 to 983. (5):
814 to 912 N·m (8 3 to 93 kgf·m, 600.3 to 672.7 lbft)