Isuzu — Isuzu N Series Training Manual

Legend 1. Adhesion type 2. Riveted type Brake Lining Removal (Riveted Type Only) 1. Remove the rivet caulking portions with a hammer and chisel. 2. Remove the rivets with a hammer and punch. N5A0140E N5A0138E 3. Inspect the brake shoe for cracking. Brake Lining Installation (Riveted Type Only) 1. Install the brake lining the rivets to the brake shoe. 2. Place the brake shoe assembly in the air hydraulic riveter. 3. Use the air hydraulic riveter to set and caulk each of the rivets. Brake Lining Thickness Measurement Use a vernier caliper to measure the brake lining thick- ness or the rivet depth.

If the measured value is less than the specified limit, the brake shoe assembly and/or the lining must be re- placed. 4. Start riveting at the center of lining and work to- wards the ends. Brake Lining and Drum Contact 1. Apply chalk powder to the entire inside brake drum surface. N5A0141E N5A0139E Brake Drum Inside Diameter mm (in) Drum size Standard Limit 279.4 300.0 320.0 279.4 (11.00) 300.0 (11.81) 320.0 (12.60) 281.0 (11.06) 301.5 (11.87) 321.5 (12.66) Out of round: • Limit: 0.13 mm (0.005 in) Brake Lining Thickness or Rivet Depth mm (in) Limit 1.0 (0.039)