Notice: Do not fail to push up the auto-adjuster lever before turn- ing the gear. Failure to do so will result in damage to the teeth of the gear because it is locked with the lever. Exercise care not to damage the boot of the wheel cyl- inder and other parts when turning the gear and pushing up the lever. N5A0166E Legend 1. Plug hole 2. Rotating direction of tire (forward) 3. Auto-adjuster lever 4. Loosening direction 5. Plug hole 6. Adjuster gear N5A0165E Legend 1. Adjuster gear 2. Brake shoe 3. Plug hole 4. Auto-adjuster lever 5.
Loosening direction Inspection and Repair Make the necessary adjustments, repairs, and part re- placements if excessive wear or damage is discovered during inspection. Brake Drum Inside Diameter Visually inspect the brake drum for excessive wear and scoring. If the brake drum is scored or worn, lathed to the speci- fied limit. Use a vernier caliper to measure the brake drum inside diameter. Drum Inside Diameter 290 mm 1. Remove the rubber cover from the brake lining clearance adjusting hole/auto-adjuster lever re- lease hole in the back plate. 2.
Insert a thin, suitable rod in the auto-adjuster lever release hole, and push the end of the auto-adjuster lever (3) in the direction of the arrow (4). 3. With the auto-adjuster lever (3) pushed up, insert a keystone tip screwdriver in the adjusting hole, and turn the adjuster gear (6) to increase the gap be- tween the gear and the brake shoe (the outside di- ameter of the shoe will decrease). Notice: Do not fail to push up the auto-adjuster lever before turn- ing the gear. Failure to do so will result in damage to the teeth of the gear because it is locked with the lever.
Exercise care not to damage the boot of the wheel cyl- inder and other parts when turning the gear and pushing up the lever. Brake Drum Inside Diameter mm (in) Drum size Standard Limit 228.6 240 260 279.4 290 300 320 228.6 (9.00) 240.0 (9.45) 260.0 (10.24) 279.4 (11.00) 290.0 (11.42) 300.0 (11.81) 320.0 (12.60) 230.0 (9.06) 241.5 (9.51) 261.5 (10.30) 281.0 (11.06) 291.5 (11.48) 301.5 (11.87) 321.5 (12.66) Out of round • Limit: 0.13 mm (0.005 in)