Isuzu — Isuzu N Series Training Manual

Windshield Wiper Motor 2. Windshield Wiper Motor 1) Disconnect the connector. 2) Remove four screws. 3) Remove the ball joint between crank arm and wiper link. N8A0263E Inspection 1. Operation in low speed With the motor connector terminal 2 connect- ed to the battery (+) terminal and the connector 1 to the ( ) terminal, check to see if the motor rotates in low speed. 2. Operation in high speed With the motor connector terminal 3 connect- ed to the battery (+) terminal and the connector 1 to the ( ) terminal, check to see if the motor rotates in low speed. 3. Stop operation After stopping the windshield wiper in the position on the way by confirming the operation at the low speed in item No.

1. When the connectors 2 and 5 are con- nected, while connecting the motor connector ter- minal 4 to the battery (+) terminal, check to see, if the motor rotates at low speed and stops at the auto-stop position. Repair or replace the motor when the results of the above inspections are found abnormal. Removal Preparation: Disconnect the battery ground cable. 1. Glove Box Refer to “INSTRUMENT PANEL” of section 2. B-11 N8A0264E B-11 Installation To install, follow the removal steps in the reverse order, noting the following points. B-11 Windshield Wiper Motor When the crank arm is removed from the wind- shield wiper motor, tighten the motor shaft nut with the specified torque. B-11 Tighten:

Shaft nut to 17 N m (170 kg cm/147 lb in) Temporarily fit the motor by using one of the four wiper motor fixing screws. B-11 B-11 B-11 Put the crank arm ball joint in the wiper link hole and fix them together while pulling the wiper link.