Isuzu — Isuzu N Series Training Manual

3. Brake Pipe Tighten the brake pipe flare nuts to the specified torque. Tighten: Brake pipe flare nuts to 16 N m (1.6 kg m / 12 lb ft) Notice: Take care not to twist the piping. N5A0151E 4) Install the brake shoes and the return springs to the wheel cylinders. Keep the brake lining clean. 5. Shoe Holding Spring, Cup and Pin 1) Before installing the holding pin. Apply a coat of molybdenum disulfide grease to the holding cup seating faces (1) contacting the brake shoe. 2) After installation of the pins, cups and the springs, make sure the pin (2) seats to the cup (3) properly. N5A0147E 4.

Brake Shoe and Return Spring 1) Before setting the brake shoes, apply a thin coat of molybdenum disulfide grease to the back plate portions (1) contacting the brake shoe edge as shown in the illustrations. 2) Apply a coat of molybdenum disulfide grease to the wheel cylinder parts contacting the brake shoe (2). N5A0152E 6. After installation of brake drum, be sure to perform the preload adjustment of hub bearing. 7. Bleed the air from brake. With Auto-adjuster For the drum brake with auto-adjuster, perform the fol- lowing procedure before Step 6 and 7. 1. Measure the internal diameter of the brake drum.

N5A0150E 3) Set the brake shoe assembly to the cylinder ad- justing screw at the brake shoe small angle end. Do not install it at the round end. Take measurement of the distance at (A), (B) and (C) points.