after the measurement. When measuring the L.S.V fluid pressure, keep the brake pedal pressed down without stepping it down twice or releasing it.) For (B), refer to the adjustment standard table. N5A0223E Legend 1. Weight 2. Platform (which is the same height as the axle weight meter) 3. Axle weight meter 2) Installation of a fluid pressure gauge Remove the air bleeder of the left hand wheel front and rear brakes. Bleed air out of the fluid pressure gauge with the measurement hose of the fluid pressure gauge installed. Pressure Tester: Brake oil (Fluid pressure gauge) 5-8840-2190-0 N5A0225E 2.
Oil Pressure Adjustment 1) L.S.V spring shackle adjustment Loosen the adjust nut of the L.S.V spring shackle, and adjust the length of the L.S.V spring shackle. When the oil pressure is insufficient, turn the adjust nut clockwise to extend the span “A”. When the oil pressure is too high, turn the ad- just nut counterclockwise to reduce the span After adjustment, tighten the lock nut securely and install the cotter pin. Tighten: Lock nut to Max.
10 N m (1.0 kg m / 87 lb in) N5A0224E 3) Rear wheel cylinder fluid pressure measure- ment Step on the brake pedal until the fluid pressure of the front wheel cylinder gets to 7845 kPa (80 kg/cm 2 / 1138 psi), and check the rear wheel cylinder fluid pressure. (Read the value of the front wheel cylinder fluid pressure 2 seconds Rear Wheel Cylinder Fluid Pressure kPa (kg/cm2/ psi) Standard (B) mm (in) Item Span adjusted Standard of span “A” 78 (3.07) Range adjustable 72 — 84 (2.83 — 3.31)