Isuzu — Isuzu N Series Training Manual

Cup and O-ring 1. Wash each part with brake oil and check for wear, deterioration, and damage. 2. Replace the cups and O-rings. Reassembly 1. Secondary Piston 2. Secondary Piston Spring 3. Spring Retainer 4. Screw 5. Secondary Cup 6. Bushing Combine secondary cup and bushing with second- ary piston as indicated as arrows, and push the as- sembly in until bushing comes into contact with cylinder body step. 7. O-ring Install the O-ring to the bushing. N5A0282E Then tighten plug to specified tightening torque. Support plate : 5-8840-2371-0 Wrench : 5-8840-2370-0 (Master cylinder inside diameter 31.7 mm, 30.1 mm) Wrench : 5-8840-2369-0 (Master cylinder inside diameter 28.5 mm) Wrench :

5-8840-2805-0 (Master cylinder inside diameter 34.9 mm) N5A0281E Notice: If plug tightened to specified torque is found floating from cylinder body, plug should be disassembled again and check for abnormal parts fitting. Then reassemble. 8. Primary Cup 9. Supporter 10. Plug and O-ring Combine primary cup and supporter with plug as indicated by arrows. Plug Torque N⋅m (kg⋅m/lb⋅ft) Master Cylinder Inside diameter (mm) 28.5 40 (4.1/30) 30.1 44 (4.5/33) 31.7 34.9 49 (5.0/37)