Isuzu — Isuzu N Series Training Manual

N5A0283E N5A0285E 11. Primary Piston 12. Primary Piston Spring 13. Spring Retainer 14. Screw 15. Supporter 16. Primary Cup 17. Bushing 1) Combined the parts of primary piston as indi- cated by arrows. Then push the assembly in until bushing comes into contact with the step in cylinder body. Support plate : 5-8840-2371-0 Wrench : 5-8840-2370-0 (Master cylinder inside diameter 31.7 mm, 30.1 mm) Wrench : 5-8840-2369-0 (Master cylinder inside diameter 28.5 mm) Wrench : 5-8840-2805-0 (Master cylinder inside diameter 34.9 mm) Notice: If plug tightened to specified torque is found floating from cylinder body, plug should be disassembled again and check for abnormal parts fitting. Then reassemble.

20. O-ring 21. Hose Joint 22. Holder Plate N5A0284E 2) Draw out primary piston alone taking care not to be let bushing get out of the step. 18. Secondary Cup 19. Plug and O-ring Combine secondary cup with plug as indicated by arrow, and tighten to specified tightening torque. Plug Torque N⋅m (kg⋅m/lb⋅ft) Master Cylinder Inside diameter (mm) 28.5 40 (4.1/30) 30.1 44 (4.5/33) 31.7 34.9 49 (5.0/37)