Chart TA-2 Uneven Braking Occurs While ABS Works (Use Tech 2) Chart A-3, TA-3 The Wheels Are Locked Step Action Value(s) YES NO 1 1. Connect Tech 2. 2. WHEEL SENSORS make sure of the out- put conditions of each sensor. Is the output of each sensor normal? — Go to Step 2 Replace wheel speed sensor. Go to Step 3 2 Check the brake pipe connecting. Is brake pipe connecting order correct? — Replace EHCU. Go to Step 4 Repair brake pipe. Go to Step 4 3 Check the wheel speed sensor and repair if necessary (Refer to chart C-1-1 to C-1-4 or TC-1). Is each chart complete? — Go to Step 4 Go to Step 3 4 Reconnect all components, ensure all compo- nents are properly mounted. Was this step finished?
— Repeat the “Basic diagnostic flow chart”. — Step Action Value(s) YES NO 1 Is ABS working? — Go to Step 2 Go to Step 4 2 Is vehicle speed under 10 km/h (6 mph)? — Go to Step 3 Normal. 3 Is sensor output normal? (Chart C-1-1 to C-1-4 or TC-1) — Go to Step 4 Replace sensor or repair harness. Go to Step 5 4 Is hydraulic unit grounded properly? — Replace hydraulic unit. Go to Step 5 Correct. Go to Step 5 5 Reconnect all components, ensure all compo- nents are properly mounted. Was this step finished? — Repeat the “Basic diagnostic flow chart”. —