Isuzu — Isuzu N Series Training Manual

Chart A-4, TA-4 Braking Sound (from Hydraulic Unit) Is Heard While Not Braking Step Action Value(s) YES NO 1 Is this the first time the vehicle is being driven after starting the engine? — It is self checking sound. Normal. Go to Step 2 2 Is vehicle speed under 10 km/h (6 mph)? — It is self checking sound. Normal. Go to Step 3 3 Check for the following condition: • At the time of shift down or clutch op- eration. • At the time of low µ drive (ice or snow road) or rough road drive. • At the time of high-speed turn. • At the time of passing curb. • At the time of operating electrical equipment switches. • At the time of racing the engine. Did it occur under any one condition above?

— ABS may some- time be actuated even when brake pedal is not applied. Go to Step 4 4 Is there play in each sensor/wheel speed sen- sor rotor? — Go to Step 5 Repair. Go to Step 7 5 Damage or powdered iron sticking to each sensor/wheel speed sensor rotor? — Repair. Go to Step 7 Go to Step 6 6 Is each sensor output normal? (Refer to chart C-1-1 to C-1-4 or TC-1). — Check harness/ connector for sus- pected disconnec- tion. If no disconnection is found, replace EHCU. Go to Step 7 Repair. Go to Step 7 7 Reconnect all components, ensure all compo- nents are properly mounted. Was this step finished? — Repeat the “Basic diagnostic flow chart”. —