Step Action Value(s) YES NO 8 Using DVM, measure the resistance between J-177 EHCU connector terminal 11 and ground. Does the DVM display a resistance within the specified value? 1000 k ohms or more Go to Step 9 Go to Step 11 9 1. Clear diagnostic trouble code. 2. Test drive and perform system self-check. Does the DTC repeat? — Go to Step 20 Go to Step 18 10 Is there damage or indentation in the speed sensor? — Go to Step 16 Go to Step 17 11 1. Disconnect FR sensor connector. 2. Using DVM, measure the resistance be- tween J-74 sensor connector terminal 2 and ground. Does the DVM display a resistance within the specified value?
1000 k ohms or more Go to Step 19 Go to Step 16 12 Adjust wheel bearing preload. Is action complete? — Go to Step 21 — 13 Repair or replace speed sensor/sensor rotor. Is action complete? — Go to Step 21 — 14 Repair speed sensor/sensor rotor. Is action complete? — Go to Step 21 — 15 Replace sensor rotor. Is action complete? — Go to Step 21 — 16 Replace FR speed sensor. Is action complete? — Go to Step 21 — 17 Check the FR speed sensor circuit. Refer to Chart 10. Is action complete? — Verify repair — 18 Check for a poor connection and an open cir- cuit on the harness between EHCU and sen- sor connectors. Refer to “Note on Intermittents” described in earlier this section. Is action complete?
— Go to Step 21 — 19 1. Locate open circuit, poor connection or short circuit on the harness between EHCU and sensor connectors. 2. Repair the harness. Is action complete? — Go to Step 21 Go to Step 21 20 Replace EHCU. Is action complete? — Go to Step 21 —