Chart 15 (DTC63/C0263) Abnormal RL Speed Sensor Signal Step Action Value(s) YES NO 21 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished? — Go to “Basic diag- nostic flow chart”. — Step Action Value(s) YES NO 1 Have the vehicle been jacked up? Have two or three wheels been turned on the brake tester intentionally? — Be careful that the system may fail if two or three wheels are turned forcibly. The flow is now complete. Repair tires. Go to Step 2 2 Are tire pressures, sizes and wear normal? — Go to Step 3 Repair tires. Go to Step 2 3 Is there play in the RL wheel bearing?
— Go to Step 10 Go to Step 4 4 Is there play in the RL speed sensor/sensor rotor? — Go to Step 11 Go to Step 5 5 Is there powdered iron sticking to RL speed sensor/sensor rotor? — Go to Step 12 Go to Step 6 6 Check the RL speed sensor. (Refer to Chart C-1-3 or TC-1) Is the RL sensor output normal? — Go to Step 7 Go to Step 9 7 Is there a broken tooth or indentation in the sensor rotor? — Go to Step 13 Go to Step 8 8 1. Clear diagnostic trouble code. 2. Test drive and perform system self-check. Does the DTC repeat? — Go to Step 17 Go to Step 16 9 Is there damage or indentation in the speed sensor? — Go to Step 14 Go to Step 15 10 Adjust wheel bearing preload. Is action complete?
— Go to Step 18 — 11 Repair or replace speed sensor/sensor rotor. Is action complete? — Go to Step 18 — 12 Repair speed sensor/sensor rotor. Is action complete? — Go to Step 18 — 13 Replace sensor rotor. Is action complete? — Go to Step 18 — 14 Replace RL speed sensor. Is action complete? — Go to Step 18 — 15 Check the RL speed sensor circuit. Refer to Chart 11. Is action complete? — Verify repair —