UNIT INSPECTION PROCEDURE Unit Inspection Procedure This section describes the following inspection procedures referred to during “SYMPTOM DIAGNOSIS” and “DIAG- NOSS BY ‘ABS’ WARNING LIGHT ILLUMINATION PATTERN”: Chart C-1-1 FL Speed Sensor Output Inspection Procedure without Tech 2 with Tech 2 Speed Sensor Output Inspection Chart C-1-1 to C-1-4 Chart TC-1 Step Action Value(s) YES NO 1 1. Turn the key off. 2. Disconnect EHCU connector. 3. Jack up the vehicle, with all wheels off the ground. 4. Measure the AC voltage between J-177 EHCU connector terminals 32 and 33 while turning FL wheel at a speed of 0.5 RPS. Does the DVM display a voltage within the specified value?
200 mV or more Go to Step 5 Go to Step 2 2 1. Disconnect FL sensor connector. 2. Using DVM, measure the resistance be- tween J-75 sensor connector terminals 1 and 2. Does the DVM display a resistance within the specified value? 1.0 — 2.0 k ohms Go to Step 4 Go to Step 3 3 1. Locate open circuit, poor connection or short circuit on the harness between EHCU and sensor connectors. 2. Repair the harness. Is action complete? — Go to Step 5 — 4 Replace FL sensor. Is action complete? — Go to Step 5 — 5 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished? — Go to “Basic diag- nostic flow chart”. —