Isuzu — Isuzu N Series Training Manual

ON-VEHICLE SERVICE Electronic Hydraulic Control Unit (EHCU) Removal 1 4 5 3 N5A1041E Legend 1. Master Cylinder (front) 2. Master Cylinder (rear) 3. Rear Right Wheel Cylinder 4. Rear Left Wheel Cylinder 5. Front Right Wheel Cylinder 6. Front Left Wheel Cylinder 2 N5A1040E Legend 1. Brake Pipe 2. EHCU Bracket Fix Bolt & Nut 3. EHCU Bracket 4. Harness Connector 5. EHCU Methods of Matching and Taking Off Connec- tors 1. Disconnect battery ground cable. 2. Disconnect brake pipes. 3. Remove EHCU bracket fix bolts & nut. 4. Remove EHCU bracket. 5. Remove EHCU. Before Matching Installation To install, follow the removal steps in the reverse order, noting the following points. Notice:

If welding work is to be performed on the vehicle using an electric arc welder, the EHCU should be removed from the vehicle before the welding oper- ation begins. Do not put a radio equipment etc, that emits strong radio wave near the EHCU. Do not wet the control unit. If wetted, wipe off water immediately and dry it fully. Never loosen any screw on the control unit. Do not paint the control unit. Prevent possible electrostatic discharge damage. Do not touch the control unit pin type terminal with a metallic tip of a screwdriver or tester. Do not apply voltage to the terminal. N5A1042E