DTC:C0215 (Flash Code 15) ECU Power Supply Fault Check flow B-4 Step Action Value YES NO 1 Is the battery voltage normal? — Go to Step2 Go to Step5 2 1. Turn the starter switch OFF. 2. Disconnect the connector of the EHCU. 3. Start the engine. 4. Measure the voltage between the J-177 connector terminal 2 and the J-177 con- nector terminal 1,23. Is the value within specified value? 17 — 33.5V Go to Step3 Go to Step6 3 Look for the circuit with improper connection. Is improper connection found? — Go to Step4 Go to Step8 4 Repair and perform the self-diagnosis. Is DTC displayed repeatedly? — Go to Step7 Go to Step8 5 Charge or replace the battery. Is this step completed?
— Go to Step8 — 6 Repair the circuit for open/short circuit, and the connector for improper connection between the J-177 connector terminal 2 and the fusible link FL-9. Is this step completed? — Go to Step8 — 7 Replace the control unit. Is this step completed? — Go to Step8 — 8 1. Install all the components, and check that those are installed properly. 2. Clear the DTC. Is this step completed? — Go to “Diagnostic basic flow”. Go to Step8