Isuzu — Isuzu N Series Training Manual

DTC:C0216 (Flash Code 16) CAN Communication Fault Check flow B-5 Step Action Value YES NO 1 1. Turn the starter switch OFF. 2. Remove the harnesses from all the con- trol units (engine, ABS, Smoother, etc.) connected to the CAN communication circuit. 3. Check for short circuit (shorts with ground, power supply, lines, and circuits) in the CAN communication circuit har- nesses. Is the harness normal? — Go to Step3 Go to Step2 2 Repair the CAN communication circuit. Is the procedure completed? — Go to Step3 — 3 1. Turn the starter switch OFF. 2. Remove the harness from the EHCU. 3.

Measure the circuit resistance between the terminals 14 and 15, and between ter- minals 26 and 27 in EHCU harness-side connector. Is the resistance within specified value? 100 —140Ω Go to Step5 Go to Step4 4 Inspect the CAN communication circuit, termi- nating resistor, and connectors for faulty con- tact, the pin terminals for looseness, etc., and repair as necessary. Is the procedure completed? — Go to Step5 — 5 1. Turn the starter switch OFF. 2. Check the CAN communication (engine, ABS, Smoother, etc.) circuit harnesses for open circuit. Is the harness normal? — Go to Step7 Go to Step6 6 Repair the CAN communication circuit. Is the procedure completed? — Go to Step7 — 7 1.

Turn the starter switch OFF. 2. Install the harnesses to all the control units connected to the CAN communica- tion circuit. 3. Turn the starter switch ON. 4. Check each system (engine, Smoother, etc) for DTC. 5. If any DTC is detected in any system, re- pair it. Is the procedure completed? — Go to Step8 — 8 1. Clear the DTC. 2. Perform the test drive. 3. Check for DTC. Was DTC C0216 detected? — Go to Step9 Go to Step10