DTC:C0241 (Flash Code 41) Fail-Safe Relay Fault Check flow B-10 Step Action Value YES NO 1 1. Turn the starter switch OFF. 2. Disconnect the connector of the EHCU. 3. Turn the starter switch ON. 4. Measure the voltage between the J-177 connector terminal 2 and the J-177 con- nector terminal 1. Is the value within specified value? 16.5 — 34V Go to Step6 Go to Step2 2 Repair the circuit between the J-177 connec- tor terminal 2 and the FL-9. Is this step completed? — Go to Step3 Go to Step2 3 Measure the voltage between the J-177 con- nector terminals 2 and 1. Is the value within specified value?
16.5 — 34V Go to Step7 Go to Step4 4 Repair the harness between the J-177 con- nector terminal 1 and the chassis ground. Is this step completed? — Go to Step5 Go to Step4 5 Measure the voltage between the J-177 con- nector terminals 2 and 1. Is the value within specified value? 16.5 — 34V Go to Step7 Go to Step5 6 Replace the EHCU. Is this step completed? — Go to Step7 Go to Step6 7 1. Install all the components, and check that those are installed properly. 2. Clear the DTC. 3. Test run the vehicle. Is this step completed? — Go to “Diagnostic basic flow”. Go to Step7