DTC:C0254 (Flash Code 54) Speed Sensor Open/Short Circuit; RR Check flow B-16 Step Action Value YES NO 1 1. Turn the starter switch OFF. 2. Disconnect the connector of EHCU and the RR wheel speed sensor connector J- 148. 3. Check for continuity between the J-177 connector terminal 12 and the J-148 sen- sor connector terminal 2. Is there continuity? — Go to Step2 Go to Step7 2 Check for continuity between the J-177 con- nector terminals 12 and 1. Is there continuity? — Go to Step7 Go to Step3 3 Check for continuity between the J-177 con- nector terminal 21 and the J-148 sensor con- nector terminal 1. Is there continuity?
— Go to Step4 Go to Step7 4 Check for continuity between the J-177 con- nector terminals 21 and 1. Is there continuity? — Go to Step7 Go to Step5 5 1. Connect the connector of the EHCU. 2. Turn the starter switch ON. 3. Measure the voltage between the J-148 sensor connector terminal 1 and the ground. Is the value within specified value? 9 — 16V Go to Step6 Go to Step7 6 Check the RR wheel speed sensor output. (Refer to the check flow C-1-4.) Is the fail corrected? — Go to Step8 Go to Step8 7 Repair the circuit for open/short circuit, and the connector for improper connection between the connector of EHCU and the speed sensor connector. Is this step completed?
— Go to Step9 Go to Step7 8 Replace the control unit. Is this step completed? — Go to Step9 Go to Step8 9 1. Install all the components, and check that those are installed properly. 2. Clear the DTC. Is this step completed? — Go to “Diagnostic basic flow”. Go to Step9