Isuzu — Isuzu N Series Training Manual

DTC:C0261 (Flash Code 61) Speed Sensor Signal Fault/Wrong Tire Size; FL Check flow B-17 Step Action Value YES NO 1 Check the tire. Is the tire specification correct? Is abnormal wear found in the outer surface? — Go to Step2 Replace with the specified tire with- out wear.Go to Step21 2 Has certain tire been rotated alone by perfum- ing for jack-up or roller tester? — DTC may be set if certain tire is rotated alone. Go to Step21 Go to Step3 3 Is the FL wheel bearing rattling? — Go to Step12 Go to Step4 4 Is the FL wheel speed sensor/sensor rotor rat- tling? — Go to Step13 Go to Step5 5 Is iron powder attached to the FL wheel speed sensor/sensor rotor?

— Go to Step14 Go to Step6 6 Check the FL wheel speed sensor. (Refer to the check flow C-1-1 or TC-1.) Is the FL sensor output normal? — Go to Step7 Go to Step10 7 Does the sensor rotor have missing tooth or saw-toothed? — Go to Step15 Go to Step8 8 Measure the resistance between the B-177 connector terminals 33 and the ground. Is the value within specified value? 1000kΩ or more Go to Step9 Go to Step11 9 1. Clear the DTC. 2. Test run the vehicle, and perform the self- diagnosis. Is DTC displayed repeatedly? — Go to Step20 Go to Step18 10 Is the speed sensor damaged or saw- toothed? — Go to Step16 Go to Step17 11 1. Disconnect the FL sensor connector. 2.

Measure the resistance between the J-75 connector terminal 2 (sensor side) and the ground. Is the value within specified value? 1000kΩ or more Go to Step19 Go to Step16 12 Adjust the preload of the wheel bearing. Is this step completed? — Go to Step21 — 13 Repair or replace the speed sensor/sensor rotor. Is this step completed? — Go to Step21 — 14 Repair the speed sensor/sensor rotor. Is this step completed? — Go to Step21 — 15 Replace the sensor rotor. Is this step completed? — Go to Step21 — 16 Replace the FL wheel speed sensor. Is this step completed? — Go to Step21 —