Isuzu — Isuzu N Series Training Manual

Remove the speed sensor before removing the hub & rotor assembly or the hub & drum assembly. Install the harness fixing bolt. Frame side Remove the speed sensor before hammering to re- move the knuckle etc. Tighten: Bolt to 22 N m (2.2 kg m / 16.2 lb ft) Use the harness line as a reference to avoid the harness from twisting, when installing the sensor harness. Tighten together with the dust cover (model with dram brake) Tighten: Bolt to 15 N m (1.5 kg m / 11.1 lb ft) To install the sensor, press-fit the sensor until the sensor flange contacts closely with the installing surface by your hand, and then tighten with the bolt.

Tighten together with the brake support (model with rigid disc brake) Tighten: Bolt to 45 N m (4.6 kg m / 33.2 lb ft) 1. Speed sensor (front) Install the speed sensor. 2. Sensor fixing bolt 4. Harness connector Install the sensor fixing bolt. Connect the harness connector. Tighten: Bolt to 22 N m (2.2 kg m / 16.2 lb ft) Inspection 3. Harness fixing bolt This section explores inspection procedures as the ref- erence to perform “Diagnostics with symptom” and “Di- agnosis with illumination pattern”. FL Wheel Speed Sensor Output Check Procedure Check flow C-1-1 Without Tech 2 With Tech 2 Speed sensor output check Check flow C-1-1 — C-1-4 Check flow TC-1 Step Action Value YES NO 1 1.

Turn the starter switch OFF. 2. Disconnect the EHCU connector. 3. Jack-up the vehicle to lift the front wheels off the floor. 4. Measure the AC voltage between the J- 177 connector terminals 32 and 33 while turning the FL wheel half turn/sec. Is the value within specified value? 200mV or more Go to Step5 Go to Step2 2 1. Disconnect the FL sensor connector J- 75. 2. Measure the resistance between the J-75 connector terminals 1 and 2 (sensor side). Is the value within specified value? 1 — 2kΩ Go to Step4 Go to Step3 3 Replace the FL sensor. Is this step completed?

— Go to Step5 — 4 Repair the circuit for open/short circuit, and the connector for improper connection between the connector of EHCU and the sen- sor connector. Is this step completed? — Go to Step5 —