Isuzu — Isuzu N Series Training Manual

FR Wheel Speed Sensor Output Check Procedure Check flow C-1-2 Speed Sensor Output Check Procedure (With Tech 2) Check flow TC-1 Step Action Value YES NO 5 1. Install all the components, and check that those are installed properly. 2. Clear the DTC. Is this step completed? — Go to “Diagnostic basic flow”. Go to Step5 Step Action Value YES NO 1 1. Turn the starter switch OFF. 2. Disconnect the EHCU connector. 3. Jack-up the vehicle to lift the front wheels off the floor. 4. Measure the AC voltage between the J177 connector terminals 10 and 11 while turning the FR wheel half turn/sec. Is the value within specified value? 200mV or more Go to Step5 Go to Step2 2 1.

Disconnect the FR sensor connector J- 74. 2. Measure the resistance between the J-74 connector terminals 1 and 2 (sensor side). Is the value within specified value? 1 — 2kΩ Go to Step4 Go to Step3 3 Replace the FR sensor. Is this step completed? — Go to Step5 — 4 Repair the circuit for open/short circuit, and the connector for improper connection between the connector of EHCU and the sen- sor connector. Is this step completed? — Go to Step5 — 5 1. Install all the components, and check that those are installed properly. 2. Clear the DTC. Is this step completed? — Go to “Diagnostic basic flow”. Go to Step5 Step Action Value YES NO 1 1. Connect the Tech 2. 2.

Check each sensor lowest speed from the “Wheel sensor”. Is the sensor speed 4km/h (2mph) or more? — Go to Step2 Go to Step6 2 Check the suspicious sensor circuit for open circuit. (Check with shaking the wire and the connector.) Is the sensor circuit connection normal? — Replace the speed sensor.Go to Step3 Repair.Go to Step3