N6A0024E N6A0026E 3. Apply a thin coat of engine oil to the O-rings. 3. After draining, securely tighten the drain plug and air intake plug. N6A0014E 4. Install the filter assemblies. Carefully turn each assembly clockwise until the O- ring is fitted against the filter cover sealing face. 5. Use the filter wrench to turn in each filter assembly an additional 1/3 to 2/3 of turn. 6. Operate the priming pump on the fuel filter to bleed the fuel system. Refer to “AIR BLEEDING” for more detailed infor- mation. N6A0027E 4. Then, operate the priming pump on the injection pump to bleed the fuel system. 5. After starting the engine, check to see that no fuel leaks from the drain plug.
Injection Nozzle Pressure and Spray Condition Check 1. Use a nozzle tester to check the injection nozzle opening pressure. If the opening pressure is above or below the spec- ified value, the injection nozzle must be replaced or adjusted. Refer to “Adjustment.” Pre-fuel Filter Water Draining Procedure The indicator light will come on when the water level in the water separator exceeds the specified level. Drain the water and foreign material from the water sep- arator with the following procedure. 1. Place the end of a vinyl hose (beneath the drain plug) in a container. 2. Loosen the air intake plug and drain plug, then drain water.