Isuzu — Isuzu N Series Training Manual

Injection Timing Adjustment Injection Pump Notched Line Inspection 1. Check the injection pump bracket nuts (1) for looseness. Tighten as required. 2. Check that the notched lines (2) on the injection pump bracket and the timing gear case are aligned. If the notched lines are not aligned, the injection timing must be checked. N6A0050E N6A0060E 3. Some time, check injection timing on the crank damper pulley. If the injection timing aligned with in correct, the in- jection timing must be readjusted. 2. Remove the two foam rubbers. 3. Loosen the four injection pump fixing nuts (1). This will allow the pump to pivot. Do not bend or scratch the fuel pipe. Injection Timing Adjustment 1.

Turn the crankshaft until the timing mark on the crankshaft damper pulley is aligned with the BTDC (injection timing of each engine model) mark in the illustration. N6A0053E 4. Align the notched line between the injection pump bracket and the timing gear case. Make sure that the timing mark on the crank damp- er pulley is aligned with correct injection timing. N6A0060E Injection Timing deg 4HF1 4HE1-TC (4HE1-XS, XN) BTDC 8 4HG1 BTDC 9 4HEI-T BTDC 7 4HE1-TC (4HE1-XS) BTDC 9 (Spec EURO3)