Isuzu — Isuzu N Series Training Manual

N6A0054E N6A0056E Notice: In case the crank pulley has two marks as illustrated, (1) BTDC 49 ° mark on the second crest and (2) TDC mark on the third crest (as viewed from the front side), be sure to set at the mark (2). (If there are two different marks on one and same crest, set at the mark which comes sec- ond when rotated in the normal direction.) The mark (1) is used when installing the injection pump for 4HF1-2. Injection Timing Check (4HF1-2 model only) 1. Set No. 1 Cylinder to the TDC in the compression stroke. 2. Disconnect Injection Pipe. 3. Put down Wax CSD lever, insert a spacer 10 — 20 mm (0.39 — 0.47 in) thick between the plunger and adjust bolt, and cancel the Wax CSD.

N6A0057E N6A0055E Legend 1. Wax CSD 2. Spacer 3. Lever 4. Water hose 5. Tighten the injection pump fixing nuts (1) to the specified torque. Tighten: Injection pump fixing nut to 25 N m (2.6 kg m/19 lb ft) 4. Remove the pump rear plug, connect a dial gage and set the lift at 1 mm (0.039 in). Special Tool Measuring device: 5-8840-0145-0